How to clamp the lead wire without damaging the sub-wire?

One method is to clamp the conductor directly on the branch conductor at a distance of 1 m with 5b (1.85g).

The other one is near the main line and sub-line of the Eighth Ring Road, with 2B bite line near the main line, and then B bite line 1.5m, and B bite line1.5m.. There are obvious differences in the fluency of fish schools.

Lead biting position:

1. In the environment with slow air volume, lead biting should be arranged near the circular ring in Figure 8, so that the effect of overcoming wind force by lead biting gravity is more obvious.

2. If the fishing gear is tilted due to the current in the environment with less wind, it should be clamped at the lower part of the auxiliary line.

3. In the windless and windless environment, lead-biting and lead-free branch lines can be arranged near the eight-character ring; Or pinch your mouth and lead it to a pair of fishing lines near the hook, but this will harden the bait. When the underflow fails, if you want to stabilize the bait, you can also hook it with a small lead according to the flow. know

4. When there is wind and flow, it is best to adopt sectional configuration and clamp the lead wire at different positions at the top, middle and bottom respectively.

Extended data:

The role of leadership:

A set of sinking lines that resist current and wind. Biting lead will make the wire sink by its own weight.

In windy weather, the wind will exert a certain force on the fishing line, pulling the fishing line and making the line group difficult to sink. If the force is greater than the sinking weight of the fishing line group, the fishing line group cannot sink smoothly and the bait cannot reach the predetermined depth. At this time, to overcome the traction of the wind, you need to bite the lead hard.

Overcome the influence of water flow and make the bait reach the predetermined depth smoothly. The force of the current acting on the wire group causes the wire group to rise. The faster the current moves, the more the line group rises. By biting the conductor, the downward gravity of the biting conductor can be used to overcome the upward swing of the pipeline assembly caused by water flow.

Stable bait. If the fishing point is too fast or the water level is low and something goes wrong, and the agitation is serious, the power of water will affect the bait to keep shaking up and down. In this case, the target fish will be very cautious and the bait will not dare to bite or bite the bait easily. Obviously, this situation has a very negative impact on fishing. This can be improved by placing a lead bite hook with an appropriate size near the hook.

References:

Baidu Encyclopedia-Introduction Clip