China Naming Network - Almanac query - How to remove the MG GT heater water tank

How to remove the MG GT heater water tank

First remove the steering wheel, then the instrument panel, and then the heater water tank. To remove the heater water tank, you need to remove the center console. Drain the coolant first, then remove the heater water pipe in the cabin, remove the center console, and remove the entire heater box assembly to remove the heater water tank. (1) Drain the coolant in the cooling system.

(2) Remove the control board.

(3) Detach the cable fixing on the left side of the heater device and remove the screws on the wire terminals.

(4) Unlock the wire connector behind the blower motor.

(5) Disconnect the vacuum tube and lighting wire behind the heater control device.

(6) Place a container under the engine and under the water supply pipe of the heater device behind the cylinder head.

(7) Disassemble the water supply pipe of the heater device behind the cylinder head.

Principle of heater water tank: In addition to a radiator in the engine compartment, there is also a heat exchanger in the dashboard of the cab. What flows in the middle is the antifreeze used for cooling in the engine. Turning on the heater can improve the car's heat dissipation, which is especially useful for some Jettas when running long distances. It uses the cooling water of the engine as the working medium. Under the action of the blower, it is blown from the same air outlet into the vehicle room to achieve the purposes of heating, ventilation and defrosting. In terms of air intake mode, it mainly has two states: one is for indoor air circulation, and the other is for outdoor fresh air to enter the vehicle interior for ventilation circulation. The blower is driven by electricity and is not affected by the engine speed. Even when the engine speed is very low, it can still perform heating and defrosting functions.