What's wrong with the high water temperature of Chery A3?
First, the water temperature caused by installation problems is too high.
1. The distance between the water tank and the engine is too large and the fan is outside the wind ring, which can be solved by adjusting the installation position of the water tank;
2. The air conditioner condenser is blocked in front of the water tank. There are two solutions: one is to change the installation position of air conditioner condenser when the engine compartment space is enough; Second, if the generator generates enough electricity, install an electric fan in front of the condenser.
Second, the water temperature caused by maintenance problems is too high.
1. The starting structure is compact and the corresponding waterway is small. In the southern region, soft water or distilled water must be added to avoid scaling in waterways; In the northern region, it is necessary to add genuine coolant to the maintenance station or regular repair shop to avoid cylinder head corrosion.
2. When the engine drains water, or when the engine is short of water, the air in the engine may not be completely exhausted after adding water for the first time. If no measures are taken, it may cause air resistance and make the engine temperature too high. The solution is: after adding water, run the engine for a few minutes, open the filler cap and fill it up again.
3. The gasoline can't reach the specified label or the ignition time is advanced, which may cause the engine to knock and make the water temperature too high. The solution is to adjust the distributor and delay the ignition time appropriately.
4. Check the oil and water before driving every day to ensure that the water tank is filled with water.
5. The fan belt is too loose, which may cause the water temperature to be too high. Belt tension can be adjusted properly.
Third, the failure of some parts may lead to excessive water temperature.
1. If the idle speed with air conditioner is too low, the water temperature may be too high. Check whether the air conditioner idle speed lifter works normally;
2. The cylinder head is uneven or the cylinder gasket is cleaned, which may cause the water temperature to be too high. The inspection method is: when the engine is cold, open the filler cap and start the engine. If there are bubbles coming out of the water tank, it may be the problem.
3. The parts of the engine cooling system are out of order, which may cause the water temperature to be too high, so the corresponding parts should be checked and replaced.
I hope I can help you!